[Mountable mugs and pots]
Many models have insufficient height for the mounting part, so it is best to check the actual product.
Not available
● Mug with a brim width of 7mm or more. *Because the width of the ground plane exceeds the allowable mounting amount.
● Mug with a cup thickness of 3mm or more * 3
* To exceed the allowable width of the hold part. (magnet)
● Trapezoidal, barrel type.
* Because the tip is facing upward in the mounting posture.
● With a mug that cleared the above conditions, the step to fit the lid inside,
* A mug with a length from the top to the convex of 11 mm to 20mm and a length from the convex wall surface to the flange tip of 7 mm or more.
〈 △or※ 〉Reason
※1 Due to the inverted trapezoidal shape and the mounting angle is bad, it tends to overflow from both sides of the mounting part. Drip is possible if handled carefully.
(Shella cup shape in general)
※2 Since the diameter is 90 mm or more, it tends to overflow from both sides of the mounting part. Drip is possible if handled carefully.
(Single mag type diameter 85mm or less recommended)
※3 Stable even with a diameter of 90 mm or more due to a spouted container
※4 Still checking.
Brim width
＞７ｍｍ NG
Mug thickness
＞３ｍｍ NG
Step from above(凸)
＞７ｍｍ NG
１１〜２０ｍｍ
Range is NG
